![]() If you need to log/visualize data with a high frequency, you might prefer the Matlab Tx block coupled with its picgui interface to retrieve data on Matlab side.Īttached are two models, one with data upload disabled (you could set the A4 pin with the switch once the target is connected to Simulink), the other one with data upload enabled (you should see the value on the digital display) Lubin Model with External-mode data upload disabled. ![]() ![]() One remark with data upload: The bandwidth required by External Mode is quite high. (see attached below) 2) If 'Enable data upload' is not enabled, the external mode only allows to set parameters (switch position, modify gain, constants etc.).ģ) With data upload enabled, you should be able to see data on scope. Hi Bizard, Few points: 1) Activate the 'Verbose' option to check whether connection is Ok or Not. Parallel To Serial Conversion Simulink Scope Chart. ![]() Parallel To Serial Conversion Simulink Scope 2. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |